JL Audio Car Speaker SB D TRKEXT 10W1 User Manual

®
Stealthbox  
I N S T A L L A T I O N G U I D E  
START  
HERE  
for the  
SB-D-TRKEXT/10W1  
(Dodge Ram  
STEP 1: Slide the front seats all the way for-  
ward and fold-up the rear bench seat.  
‘94-’01 1500 Club Cab,  
‘98-’01 1500 Quad Cab,  
‘94-’02 2500 Club Cab,  
‘98-’02 2500 Quad Cab,  
‘95-’02 3500 Club Cab,  
‘98-’02 3500 Quad Cab)  
STEP 2: Under the rear bench seat, there are  
a pair of metal brackets which hold the tire  
changing tools. Bend these up and back so  
they are out of the way of then enclosure.  
This Stealthbox is a product which  
requires professional installation skills and  
tools.  
Please read this installation guide thor-  
oughly before beginning the project. It  
will guide you step by step through the  
installation. Several of the steps in this  
process may require two people to  
accomplish.  
It is absolutely vital that the enclosure  
be properly mounted to the vehicle  
according to these instructions. Failure  
to mount the enclosure properly pres-  
ents two problems: 1)The sub-bass  
performance will suffer due to the  
movement of the enclosure caused by  
the force exerted by the woofer(s) and  
2) A loose enclosure presents a serious  
safety hazard in the event of a collision  
or sudden deceleration.  
STEP 4: Place the other supplied wax square  
to this location. (remove paper, sticky side  
down).  
STEP 3: Place one of the two supplied wax  
squares to this location(remove paper, sticky  
side down).  
The rear edge needs to be 5-1/2” from the  
back of the cab.The inside of the wax square  
needs to be 5-1/2” from the outside edge of  
the carpet.  
The outside edge of the wax square needs to  
be flush with the jack storage compartment.  
The rear edge needs to be 5-1/2” from the  
ledge at the back of the cab floor.  
Please enjoy your JL Audio Stealthbox  
responsibly.  
Continued on Next Page  
SB-D-TRKEXT/10W1, JL AUDIO, Inc 2004  
Page 1  
Sheet SKU#011105 Revision6/28/2004  
 
Cont.  
From  
Previous  
Page  
THREADED INSERT  
STEALTHBOX WALL  
STEP 10: Place the enclosure back into the  
mounting location Line up and guide the two socket  
cup set screws through the drilled holes from  
STEP 8.  
CONGRATULATIONS!  
INSTALL COMPLETE.  
VEHICLE SHEET METAL  
SOCKET CUP SET SCREW  
FENDER WASHER  
FLAT WASHER  
LOCK WASHER  
HEX NUT  
Included Hardware:  
(2) 3/8”-16 X 2-1/4” Socket Set Screw  
(2) 3/8” Fender Washers  
(2) 3/8” Flat Washer  
(2) 3/8” Lock Washer  
(2) 3/8’-16 Hex Nut  
STEP 9: Double check the woofers for proper  
functioning.  
STEP 11: With the supplied hardware, place as in  
order of direction.  
Run speaker wire to the enclosures mounting loca-  
tion and secure it to the wire terminal on the enclo-  
sure.  
Place the fender washer, flat washer, lock washer and  
then hex nut onto the protruding socket cup set  
screws.  
Adjust the socket cup set screws for more or less  
threads that are needed. Hand tighten the nuts, till  
both mounting assemblies are on.  
Tighten securely.  
Difficulty Of Installation:  
Mid/High Frequency Driver Information:  
Specifications:  
Enclosure Type: Acoustic Suspension (Sealed)  
Driver Type: (2)10W1-8  
Nominal Impedance: 4  
Cont. Power Handling: 250Watts  
Front Location Driver Size:  
6”x9”  
Applicable JL Audio Products:  
N/A  
JLAudio recommends using a high quality amplifier such as the JLAudio 250/1. The diagram below shows the recommended  
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.  
Rear Location Driver Size:  
5.25”  
+12VDC  
Ground Remote  
Preamp Output Section  
Output Mode  
Bass Control  
Infrasonic Filter  
Amp LP Filter  
Mode/Slope  
Amplifier Input Section  
XR525-CXi  
Input Voltage  
Input Sens. Signal Sensing  
Applicable JL Audio Products:  
TR,VR,XR525-CXi  
Full-Range/Low-Pass/High-Pass  
Off/30Hz  
+7  
Off/12dB/24dB  
Low/High  
Off/On  
+3  
+1  
+10  
+13  
JL AUDIO 250/1  
monoblock subwoofer amplifier  
Left Ch.  
Right Ch.  
LF Boost (dB) Filter Freq. (Hz)  
Left Ch.  
Right Ch.  
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information  
about installing and tuning this amplifier.  
10369 N. Commerce Pkwy, Miramar, Florida 33025-392  
Phone: 954.443.1100  
Fax: 954.443.1111  
SB-D-TRKEXT/10W1, JL AUDIO, Inc 2004  
Page 3  
Sheet SKU#011105 Revision6/28/2004  
 

Indesit Cooktop KP900CX User Manual
JVC Cassette Player HR P500K 100A User Manual
JVC Computer Drive MC D207U User Manual
JVC Digital Camera GR DX106 76AG User Manual
JVC VCR LPT0800 001B User Manual
JVC VCR Model HR DVS1U User Manual
Kenmore Vacuum Cleaner 11634924 User Manual
Keys Fitness Treadmill 5500T User Manual
Kramer Electronics Postal Equipment VP 471 User Manual
Kramer Electronics TV Cables PT 101Hxl User Manual